Because the work in the communications industry always touches the mobile phone, and usually prefers to disassemble and disassemble, from the beginning of the iPhone 4 there must have been demolished dozens of mobile phones, and some are to help repair, while others are purely interested in dismantling to see the structure, Thinking that there is no official record yet, let's share this platform with everyone on this aunt:
Note: This time using the prototype iPhone 6, iPhone 5, 5s, 6, 6s, 7 are similar structures can refer to, but 4/4S is not suitable!
1, disassemble preparation, first you need a star screwdriver (open bottom screw), Phillips screwdriver (open internal screw), suction cup (sucking open the screen), Alice bar (shake the screen gap and cable clips), magnetic screw Board (place screws and metal brackets); 2. Firstly, perform the first step and unscrew the two screws on the two sides of the charging port at the bottom of the iPhone with a star-shaped screwdriver, as shown in the following figure:
2, after the screw is removed, suck the screen from the front of the phone through the suction cup and gently separate the camera from the screen: PS: Note that this step must be careful with the screen, evenly after gently sucking open the gap can be properly used in the rod Flutter around the metal frame, the screen is precious, we must be careful and careful to say three! ! ! (Ifixit's tools are used in the figure, conditions can be considered)
3, after the screen is opened, to a front structure diagram, the original can be simply replaced are listed, if you have the need to be careful to replace:
4. Remove the 5 screws on the screen cover and place it. Gently open the cable to remove the screen. (The old driver can not remove the screen. The removal is to facilitate the subsequent removal of the battery, so as to avoid the screen hanging. Tightly bending the battery on the top can damage the screen cable:
5, remove the screen and remove the battery cover and screws placed, at this time through the stick (bank card) gently probe into the bottom of the battery to gently separate the battery and the middle of the body of the glue, the conditions of the students can use the air gun It's easier to disassemble and prepare new batteries and battery glue to be replaced: PS: Please note that this step must be done slowly whether you are heating or tilting the battery, because the BNM has some quality problems with the iPhone 6/6S battery. Excessive temperature or excessive force can cause the battery to ignite or even explode!
6, the battery glue evenly stuck in the metal fuselage battery position, according to the original battery position to install a new battery, gently buckle the cable, screw on the battery cover and screws:
7, gently buckle the screen cable, install the screen cover and 5 screws, gently buckle the screen back to the fuselage, this step should be carefully observed around, fully buckled, then there should be no gaps, tighten the bottom two Screw, turn on the light:
Tell everybody, see here, has completed the process of changing the battery, if there are other problems you can leave a message and contact me, I wish you a happy Lantern Festival in advance!
VFD Linkage
Sewing Machine Accessories,No Burr Sewing Machine Accessories,High Precision Sewing Machine Accessories
SHAOXING HUALI ELECTRONICS CO., LTD. , https://www.cnsxhuali.com