Biochemical incubator using methods and precautions - Database & Sql Blog Articles

Probe domestic switch needle KG-300K needle head diameter is 3.0mm normally open switch needle

Biochemical incubator is a commonly used incubator product. It is a special thermostat for water body analysis and BOD determination, cultivation, preservation, plant cultivation and breeding experiments of bacteria, mold and microorganisms. How should users use biochemical incubator products? The following small series will introduce the use method and precautions of biochemical incubator, hope to help everyone.

Biochemical incubator use method

1. Open the box door, put the object to be processed into the shelf on the box, and close the box door.

2, connected

power supply

Insert the three-pin plug into the power socket and set the power switch on the panel to the "on" position.

meter

A digital display appears indicating that the device is in working condition.

3. By operating the temperature on the control panel

Controller

, set the temperature inside the box you need

When the set temperature is greater than the ambient temperature by 5 ° C or above, set the cooling transfer switch to "RT + 5 ° C". (For detailed operation instructions of the temperature controller, see the next page.)

4,

When the work starts, the temperature inside the box gradually reaches the set value, and after the required processing time, the processing is completed.

5. Turn off the power supply. After the temperature inside the box is close to the ambient temperature, open the door and take out the object.

Biochemical incubator use precautions

1. Do not put flammable and volatile chemicals into the box.

2. If abnormality, odor, smoke, etc. occur during use, please turn off the power immediately. Users should not blindly repair it. They should inform the repair department of the company and check it out by professionals.

3. The wall of the tank wall and the surface of the equipment should be wiped frequently to keep it clean and increase the transparency of the glass. Do not use acid, alkali or other corrosive solutions to wipe the outer surface.

4. When the equipment is not in use, it should be treated with moisture. The specific method is as follows:

Pour the water from the bottom of the tank to the water tray, set the temperature to 42 ° C, run for 5 hours, and open the door every two hours to release the moisture. After the treatment is completed, unplug the power plug and store it.

5. If the equipment is not used for a long time, the power cord should be unplugged to prevent equipment damage. It should be operated regularly (usually in the first quarter) for 2-3 days according to the conditions of use to remove the moisture from the electrical parts to avoid damage.

Device

.