The software source is an application installation library, and many, many applications are in this library. He can be a web server, a CD, or even a directory on a hard drive. The openwrt source sometimes downloads the source from the server abroad slowly, and sometimes it cannot be downloaded due to the DNS problem. This article describes in detail the two methods of openwrt modified to the domestic software source. Please see below.
Openwrt changed to domestic software source method one:1.SecureCRT or putty connect openwrt router and execute opkg update update list error
2. LUCI interface execution is the same
3. So we will modify the default source to a third-party source, SecureCRT or putty login router
Execute cp /etc/opkg/distfeeds.conf /etc/opkg/distfeeds.conf.bakup (back up for future use)
Execute vi /etc/opkg/distfeeds.conf
4. Press the number a edit mode to replace the third-party source as shown in the figure.
Before the replacement, we will compare the original source https://downloads.openwrt.org/chaos_calmer/15.05.1/ramips/rt3883/packages/base with the third-party source http://. We found that it only changed the front of 15.05.1. The address can be replaced with a third party by the official address of the push bar.
After the replacement is complete, press esc to propose the edit mode: wq! Save exit
5. Finally, let's verify that we execute opkg update again.
OK Finish Now you can install the software!
1. Method 1 uses ssh to modify the source address. The following describes how to use LUCI to modify the address to log in to the router page.
2. Enter the system-package-configuration
Modify the address in the distribution feed (that is, the map) DistribuTIon feeds as a third-party source
3. Refresh the package
Nantong Boxin Electronic Technology Co., Ltd. , https://www.ntbosen.com